Evolv DNA Forum
Sign up Calendar Latest Topics
 
 
 


Reply
  Author   Comment  
Markyt123

Junior Member
Registered:
Posts: 12
Reply with quote  #1 
I have a question which might be dim. I've run wire wizard with the coil spec I've built. The ohms generated is .6 on wire wizard
I've installed 2 coils which reads .31 on my DNA 250. My question is; is the .6 ohm csv I've taken from wire wizard ok to install onto escribe even though with 2 coils the mod reads .3. Furthermore, does it make that much difference from the standard ss316 profile already installed?

ChunkyButt200

Avatar / Picture

Administrator
Registered:
Posts: 1,516
Reply with quote  #2 
it should be fine to use. there might be little to difference in the vape from either profile. whatever you like best, use.
__________________
1.21 JIGAWATTS............GREAT SCOTT!........WHAT THE HELL IS A JIGAWATT?
• I am not employed by nor do I represent Evolv Inc.  All opinions are my own, they are just opinion not fact and can be wrong •
Latest versions of EScribe: DNA 200 • DNA 75  Common problems
EVOLV HELP DESK - https://helpdesk.evolvapor.com/?a=add
LOST VAPE WARRANTY REPAIR - http://www.lostvaperepaircenter.com
Markyt123

Junior Member
Registered:
Posts: 12
Reply with quote  #3 
Cheers for the response.
Dampmaskin

Avatar / Picture

Member
Registered:
Posts: 79
Reply with quote  #4 
Was the 0.6 Ohm figure for a single coil? If so, it makes sense that a dual coil will read close to 0.3 Ohm.

In any case, the TCR will be unaffected.

__________________
Steam Engine Wire Wizard with TCR
Markyt123

Junior Member
Registered:
Posts: 12
Reply with quote  #5 
Excellent! Thanks for the response. Learning as I go!
Previous Topic | Next Topic
Print
Reply

Quick Navigation:

Easily create a Forum Website with Website Toolbox.