Evolv DNA Forum
Sign up Calendar Latest Topics
 
 
 


Reply
  Author   Comment  
manos58

Junior Member
Registered:
Posts: 5
Reply with quote  #1 
Is there a way to erase certain profiles with e-scribe and then upload some of my liking ?
I go to materials on device ,I check sweet spot 1 but doesn't let me erase it .
On the other hand on profile No8 been empty I uploaded a profile I made and this one is erasable .
What am I doing wrong ?
giz_60

Avatar / Picture

Senior Member
Registered:
Posts: 796
Reply with quote  #2 
If the material is in a profile, you can't erase it...
manos58

Junior Member
Registered:
Posts: 5
Reply with quote  #3 
so,no way to re organize the profiles or I have to overwrite a new profile as if it was blank ?
giz_60

Avatar / Picture

Senior Member
Registered:
Posts: 796
Reply with quote  #4 
You can copy one profile to another...say you want to move profile 7 to the profile 2 slot...open profile 2, go to 'Copy Profile' and select profile 7...is that what you are asking?
manos58

Junior Member
Registered:
Posts: 5
Reply with quote  #5 
No .I want to make 2-3 new profiles with ss316 clapton wires and put them in the places of SSV 1,2&3 that are Ti settings which i am not going to use .I can make the csv files in Steam engine ,save them but no place to upload them on the device .Unless I can overwrite a profile instead of erasing it .
giz_60

Avatar / Picture

Senior Member
Registered:
Posts: 796
Reply with quote  #6 
Yes, you can overwrite existing profiles. You will have to move the material to the device in the 'Material Tab' and then you can overwrite the T1 profiles using the 316L for the material & set the pre-heat, etc. where you want it...In the materials tab, click on the 316L .csv on the 'Available Materials' side, and the click the little arrow to send it to the "Materials On Device' side, then you can build your profiles using the 316L
retird

Avatar / Picture

Administrator
Registered:
Posts: 1,187
Reply with quote  #7 
WITH A NEW DEVICE YOU SHOULD MAKE A BACKUP COPY OF YOUR .ECIG FILE BEFORE MAKING CHANGES.... JUST MY OPINION... [smile]

VS has setup those custom profiles on the device side for SSV material. You notice there is no SSV wire shown in the Available Materials list. VS does a great job configuring it's Switchbox but the SSV default profiles on the device is not something you will commonly see on other DNA's. 

In the Material tab:

You might try moving the profile which is on the Device side of Material back to the Available Material side. 

Then go to the General Tab, select that profile number for the one you moved and make your changes and upload.

__________________
I am not an employee of and do not represent Evolv Inc.  My opinions are just that and are not meant to be fact or even correct.

manos58

Junior Member
Registered:
Posts: 5
Reply with quote  #8 
Thank you both .I'll try and I'll post the results .
giz_60

Avatar / Picture

Senior Member
Registered:
Posts: 796
Reply with quote  #9 
In case you are in need of it, here is the factory .ecig file...ecig Switchbox DNA75.ecig     
manos58

Junior Member
Registered:
Posts: 5
Reply with quote  #10 
thanks again .I did as you suggested and worked fine .Problem solved
giz_60

Avatar / Picture

Senior Member
Registered:
Posts: 796
Reply with quote  #11 
[thumb][thumb]
Previous Topic | Next Topic
Print
Reply

Quick Navigation:

Easily create a Forum Website with Website Toolbox.