Registered: 1444570777 Posts: 187
Reply with quote
Hi everyone, I have a question regarding SS316L and temp control with the SP5 1.2 update.
I could never get SS316L to work well on my DNA200's, until SP3. When I updated to this, I found it to work as well as my DNA75's, and changed it to my main wire type. (EDIT: I should add, it was the included SS 316 profile with the update that I found to work best. I am still using the same one, so am unsure why this is now happening- is it even possible it is the service pack?) I updated two of my DNA200's yesterday after updating Escribe, and now am having the same issues as before SP3 with the mods I updated. The ones still on SP3 are working well. Temp protect is hit immediately, and no vapour is produced, even if I turn up the temp all the way to 300C. (EDIT: Hmm, it does seem to be behaving the same way as I remember- sometimes it fires, and the temp is not reached, others it seems to be registering far too early, and dropping power far too much). Is this a known issue, and if so, can I revert to SP3 on these two mods? I was very happy with the performance before, so would like to get it back working this well
Registered: 1435637569 Posts: 304
Reply with quote
Make sure the board is well-grounded. If the grounding screws are making poor contact, Ohms can shift as power rises.
1.2 SP5 introduced an overtemperature failsafe (that is, if it measures a temperature well over what it should be controlling at, it assumes the wire is out of control and cuts power). In practice this does not occur often, but it can due to Ohms misreading if you have a grounding issue. Barring everything else, you can certainly revert back to SP3. EScribe should be compatible with it long-term. If it ever stops being compatible let us know.