Registered: 1444570777 Posts: 187
Reply with quote #1
Hi everyone. EDIT: Apologies, I have found that 2.75V is fine as a soft cell cut off reading the forum-please disregard this as it was already covered and my fault for not noticing.
Today I got a SMY DNA75, that comes preset by DJlsb vapes, and noticed in the manual the soft cell cutoff is 2.75V, and checking on Escribe it is set at this level. Reading the data sheet for the 25R, I understand it is useable down to 2.5V, so is it OK to keep the setting of 2.75V for the soft cell cut off, or would it be best for me to raise it? I understand this setting is under load, and on some of my other mods batteries can sag to around 2.8V before the mod will not fire (Non customisable regulated devices). So, am I OK keeping the cutoff here, or should I raise it, and if so, what would be a good level to raise it too? Thanks everyone, Conan.
Registered: 1435923125 Posts: 1,248
Reply with quote #2
I left mine there. I think most did also.
__________________ I am not connected with and do not represent Evolv Inc. All opinions are my own. They are just opinions and may not be correct.
Registered: 1437592337 Posts: 1,516
Reply with quote #3
my 2 cents...... i have my CSC set to 2.68V anything lower and the dna 75 gets angry and starts throwing error messages when battery gets low and you hit the cutoff. FWIW most cell manufacturers test their cells down to 2.5v like you said, so 2.68 - 2.75 will NOT hurt the cell.
__________________ 1.21 JIGAWATTS............GREAT SCOTT!........WHAT THE HELL IS A JIGAWATT? • I am not employed by nor do I represent Evolv Inc. All opinions are my own, they are just opinion not fact and can be wrong •