Evolv DNA Forum
Sign up Calendar Latest Topics
 
 
 


Reply
  Author   Comment   Page 4 of 4      Prev   1   2   3   4
macz

Senior Member
Registered:
Posts: 121
Reply with quote  #46 
Try remove the board from the enclosure and fire it via onboard buton directly, see if still continue firing after letting it go
antyac2108

Member
Registered:
Posts: 87
Reply with quote  #47 
It still does it out of the enclosure
macz

Senior Member
Registered:
Posts: 121
Reply with quote  #48 
Is that case go here for RMA
antyac2108

Member
Registered:
Posts: 87
Reply with quote  #49 
i was talking to john about this yesterday and i haven't heard anything from him today about it
John

Avatar / Picture

Administrator
Registered:
Posts: 500
Reply with quote  #50 
If it is showing voltage on the button while it continues to perma-fire, then that is going to be a hardware issue. PM me your address and I'll get another one and a return tag out to you today, so I can see what's going on with that one.

Thanks
John
antyac2108

Member
Registered:
Posts: 87
Reply with quote  #51 
Thank you I just pm you my address
John

Avatar / Picture

Administrator
Registered:
Posts: 500
Reply with quote  #52 
You should have a replacement board arrive Friday, and a UPS label to send your existing one back so we can see where it is getting the fire signal from. 
antyac2108

Member
Registered:
Posts: 87
Reply with quote  #53 
Ok much appreciated.
John

Avatar / Picture

Administrator
Registered:
Posts: 500
Reply with quote  #54 
Actually, before you send it back (your new one is already on the way, but if we get this figured out and you end up with two, merry christmas) try pulling the output wire off the board and see if it still auto-fires. The large exposed silver via you circled won't cause the board to auto-fire, but if your output wire was shorted to the smaller green-covered via next to it, that absolutely COULD cause what you're seeing.


sgtmonty

Junior Member
Registered:
Posts: 12
Reply with quote  #55 
@antyac2108 did you figure out what was happening with your board? I have the same or similar issue, and am at a loss for an explanation. I am going to try all the things suggested on this thread and hopefully I figure it out.
antyac2108

Member
Registered:
Posts: 87
Reply with quote  #56 
I think it's the tact switch but I sent mine back to evolv I would private message John.
Previous Topic | Next Topic
Print
Reply

Quick Navigation:

Easily create a Forum Website with Website Toolbox.