Evolv DNA Forum
Sign up Calendar Latest Topics
 
 
 


Reply
  Author   Comment  
Jez650

Junior Member
Registered:
Posts: 7
Reply with quote  #1 
Hi guys, I have just received a pair of sBody Elfins and seen to have a problem with one of them. When I put an atty on and press fire, the screen reds Ohm's too high. I have tried multiple atty's, all the same. The second mod is working perfectly.
Any ideas?
I was wondering if it might have a dodgy 510 connection?
 
ChunkyButt200

Avatar / Picture

Administrator
Registered:
Posts: 1,516
Reply with quote  #2 
are you reaching the 6.2 volt limit of the dna 75? if your coils are .5 and above and you're trying to run them at the upper wattage limit you'll get that message.
__________________
1.21 JIGAWATTS............GREAT SCOTT!........WHAT THE HELL IS A JIGAWATT?
• I am not employed by nor do I represent Evolv Inc.  All opinions are my own, they are just opinion not fact and can be wrong •
Latest versions of EScribe: DNA 200 • DNA 75  Common problems
EVOLV HELP DESK - https://helpdesk.evolvapor.com/?a=add
LOST VAPE WARRANTY REPAIR - http://www.lostvaperepaircenter.com
Jez650

Junior Member
Registered:
Posts: 7
Reply with quote  #3 
Yeah, but the same Atty works fine on the other identical mod. Tried 3 other Atty's that all work on the other mod, not on this one.
awsum140

Avatar / Picture

Senior Member
Registered:
Posts: 203
Reply with quote  #4 
If you can short out the 510 on the mod that's giving you problems that should tell the tale.  It should read "ohms too low" under a "dead short" condition. To do that safely, attach to eScribe and open the atomizer analyzer.  In fact, atomizer analyzer will show you what is going on with the mod even with the atomizer attached, but shorting the 510 will be the "proof of the pudding".  From what you're saying I'll guess the mod has a problem.
Jez650

Junior Member
Registered:
Posts: 7
Reply with quote  #5 
Thanks, I think I have a mod problem. I put a velocity RDA on that I wrapped with plenty of Kanthal and got a reading of 0.08 Ohm's on my Ohm reader on and Ran the Atomizer Analyzer, It just came up with a BIG ? and the screen keeps flashing "Ohm's Too High" 
Bugger!!
Anyone know if this is likley to be a board problem or possibly a dodgy wiring solder point or similar?
Previous Topic | Next Topic
Print
Reply

Quick Navigation:

Easily create a Forum Website with Website Toolbox.