Evolv DNA Forum
Sign up Calendar Latest Topics
 
 
 


Reply
  Author   Comment  
wojzilla

Junior Member
Registered:
Posts: 12
Reply with quote  #1 
EDIT: In my haste i posted in the wrong subforum - could a mod please move me where I need to go?

Hi All,

I have a custom built DNA 200 that auto fired (ended up pulling the RDA off)
It worked fine the following day but now it is very slow to register button presses (if at all).

  • Using the device buttons I can't lock/fire/adjust watts/temperature
  • When I control it with E-Scribe it works fine (firing/adjustment)
  • The display doesnt go to sleep - stays at full brightness
  • When charging the display doesn't change to the charging screen either.
  • I have tried a soft boot and hard boot
  • The battery is soldered onto the board so I haven't tried cutting power.
  • If I have an RDA connected it will auto fire after i upload settings to device or if there's no RDA connected it will flash check atomizer 19 times.
  • No idea what wattage it fired at (set to 80 watts) however the dual Stainless Steel coil ended up melting at the screw terminals rather quickly (and thankfully stopping firing)
  • Atomizer Analyzer always reads 0.2 ohms, screen shows 0.00

Firmware version installed 2015-08-21
wojzilla

Junior Member
Registered:
Posts: 12
Reply with quote  #2 
  • Battery unsoldered and board removed from enclosure
  • still flashes Check Atomizer when plugged in to USB (same as observed in my first post)
  • Fire button = no change on screen
  • Up = Check Atomizer (as if it's trying to fire)
  • Down = check atomizer (as above)
  • Rolled back firmware to 2015-08-07

Ideas?


Podunk Steam

Avatar / Picture

Senior Member
Registered:
Posts: 140
Reply with quote  #3 
Check your presets for wonky settings? 
__________________
Founder of Magic Valley Vapors
wojzilla

Junior Member
Registered:
Posts: 12
Reply with quote  #4 
Presets checked, all looks fine - fires ok when controlled by EScribe, has issues when controlled by the board.
blueridgedog

Avatar / Picture

Moderator
Registered:
Posts: 573
Reply with quote  #5 
And you are certain that the assembly is not putting pressure on the fire button...i.e. you can press it and note that it is "clicky" and not depressed constantly?  If it auto fires and there is no actual pressure on the button, then you will need to return the chip/mod.
wojzilla

Junior Member
Registered:
Posts: 12
Reply with quote  #6 
yep 100% sure - even took it out of the bezel (using Mamu's off shapeways) and out of the enclosure.
Thanks for the suggestion though - I have contacted Evolv's support - hopefully they have a fix. I have seen a few posts with similar (not the same) issues.
raul_q

Junior Member
Registered:
Posts: 4
Reply with quote  #7 
Hey did evolv answer you about the problem? I'm having the same issue here.
badow24

Junior Member
Registered:
Posts: 7
Reply with quote  #8 
Hey got the same problem wojzilla. Ever figure out your problem?
Previous Topic | Next Topic
Print
Reply

Quick Navigation:

Easily create a Forum Website with Website Toolbox.